NEC SL1000 - Page 747

5. Press Hold. You can set Name (PRG 13-04-02).
ABB0001
-
6. Press Hold and Enter the Transfer Mode 0 ~ 3 (PRG13-04-03).
TRF0 = Not defined
TRF1 = Internal Dial
TRF2 = IRG
TRG3 = Remote Monitor
ABB0001
TRF (0-3)?0-
7. Press Hold and Enter the Ringing Destination (13-04-04).
If you Select TRF1 ~3 following can be entered/
TRF1 (Internal Dial): Up to 36 digits
TRF2 (Incoming ring Group): 0-25
TRF3 (Remote Monitor): Dial Up to 4 digits
If you press Exit Key you can clear the digits you entered.
ABB0001 MXTarget
MX = X is Mode 1 ~3 (13-04-03)
8. Press Hold and you enter the Incoming Ring Pattern (13-04-05).
0 ~ 9 can be entered and 0 ~ 9 are followings:
0 = Normal pattern
1-4 = Tone pattern (1-4)
5-9 = Scale pattern (1-5)
ABB0001 ModeX
Ring (0-9)? 1-
ModeX = X is Mode 1 ~3 (PRG 13-04-03)
9. Enter the VRS Incoming Message Number : 000 ~ 100 (13-04-07).
ABB0001 MX VRS
001
MX = X is Mode 1 ~3 (PRG 13-04-03)
10. If you set correctly you will hear the Confirmation Beep and see the following Screen.
Set ABB
11. Press Speaker and end the Setting.
ISSUE 2.0
SL1000/SL1100
Features and Specifications Manual 1-737
V