NEC SL2100 - Page 177

Caller ID Flexible Routing
Program
No.
Program Name Input Data Default
13-04-01 * Speed Dialing Number and Name - Number Maximum of 36 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer Supervision
- ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
13-04-03 * Speed Dialing Number and Name - Transfer
Mode
0 = Not Used (Calls will not be
routed based off a users caller
ID.)
1 = Internal Dial (Calls will be
routed to an internal number
specified in PRG 13-04-04.)
2 = Incoming Ring Group (Calls
will be routed to a ring group
specified in PRG 13-04-04.)
3 = Remote Monitor (Used for
the security feature and not Flex-
ible Caller ID routing.)
0
13-04-04 * Speed Dialing Number and Name - Transfer Des-
tination Number
If Transfer mode is (Refer to
13-04-03) :
1 = Internal Dial Mode
1 ~ 9, 0,
*
, #, P, R, @
P = Pause
R = Recall
@ = Additional Digits when using
ISDN functionality
(Maximum 36 Characters)
2 = Incoming Ring Group
0 ~ 50 (IRG Number)
3 = Remote Monitor
Dial (Up to 8 digits)
No Setting
13-04-05 Speed Dialing Number and Name - Incoming
Ring Pattern
0 = Normal System Ring Pattern
1 ~ 4 = Tone Pattern 1 ~ 4
5 ~ 9 = Scale Pattern 1 ~ 5
10 ~ 13 = Tone Pattern 5 ~ 8
0
Caller ID Refuse for Specific Numbers
Program
No.
Program Name Input Data Default
14-01-27 * Basic Trunk Data Setup - Caller ID Refuse Setup 0 = Disable (CID refuse will not
function.)
1 = Enable
0
22-16-01 * Private Call Refuse Target Area Setup - Speed
Dial Group Number
0 ~ 50
0 = No Group Assigned (Caller
ID refuse will not function.)
0
13-02-01 * Group Speed Dialing Bins 0 ~ 999 = Speed dial bins 0 ~
999
0
13-04-01 * Speed Dialing Number and Name - Number Maximum of 36 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer Supervision
- ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
ISSUE 1.0 SL2100
Features and Specifications Manual 1-163
C