NEC SL2100 - Table 1-8 Dial Tone Detection Program Interaction

Guide to Feature Programming
Program
No.
Program Name Input Data Default
10-09-01 DTMF, Dial Tone Detection Setup - DTMF, Dial
Tone Detection
0 = Common use for both analog
extensions and trunks
1 = Use for analog extensions
(DTMF Receivers)
2 = Use for analog trunks (DTMF
receivers/Dial tone detection/
Caller ID detection)
Resource 01 ~ 140 = 0
14-02-05 Analog Trunk Data Setup - Dial Tone Detection
for Manually Accessed Trunks
0 = Dial Tone Detection Not
Used
1 = Dial Tone Detection Used
0
14-02-11 Analog Trunk Data Setup - Next Trunk in Rotary
if No Dial Tone
0 = Disable (No)
1 = Enable (Yes)
0
21-01-04 System Options for Outgoing Calls - Dial Tone
Detection
0 ~ 64800 seconds 5
21-01-05 System Options for Outgoing Calls - Disconnect
Time when Dial Tone not Detected
0 ~ 64800 seconds 3
21-01-06 System Options for Outgoing Calls - Dial Pause
at First Digit
0 ~ 64800 seconds 1
Table 1-8 Dial Tone Detection Program Interaction
Method 14-02-05 14-02-11 Result if dial tone not present . . .
Press a line key
- or -
Dial #0 + Trunk number
0 0 Trunk hangs (does not disconnect)
0 1 Trunk hangs (does not disconnect)
1 0 Trunk drops
1 1 Trunk drops
Dial a Trunk Group code
- or -
Automatically through a feature
0 0 Trunk hangs (does not disconnect)
0 1 Trunk reroutes after time-out
1 0 Trunk drops
1 1 Trunk reroutes after time-out
Operation
Dial Tone Detection is automatic if enabled in programming.
SL2100 ISSUE 1.0
1-242
Dial Tone Detection
D