<< Alarm Report 05/16/2006 14:30 PAGE 001
LVL NO STAT DATE TIME ITEM UNIT SLT PRT PARAMETER
MIN 0068 ERR 01/22/09 09:40 VoIP All DSP
Busy
VoIPDB 01 00 NET
Table 1-3 Alarm Report Definitions
Alarm Report Heading Definitions
LVL Alarm Type (MAJ = Major, MIN = Minor)
NO Number of Alarm (4-digit)
STAT Status (REC = Recovered, ERR = Error, WAR = Warning
DATE Date the Alarm Occurred
TIME Time the Alarm Occurred
ITEM Name of the Alarm
UNIT Name of the Board
SLT Chassis Slot Number
PRT Chassis Port Number
PARAMETER Related Information
Table 1-4 Alarm Report Item Definitions
Item Name Definition
PKG Installation Board is removed or inserted.
ISDN Link ISDN Line failure is detected.
CPU LAN Link CPU LAN connection failure is detected.
Blocking Terminal Failure may have occurred because terminal blocking is detected. Termi-
nal is unplugged or wire is disconnected.
System Data Change System Upgrade performed or Programming change.
System Start Up System is reset.
SMDR Link Connection failure is detected between the CPU and SMDR printer device.
STA DSP for IP Station Call were all busy.
TRK DSP for Trunk Call were all busy, includes SIP trunks.
NET-DSP SL Net Call when all DSP resource is busy.
Conditions
• Alarm reports can not be stored on SD card in SL2100.
• The supports the following Alarms to be output to the LCD of a Multiline Terminal:
- SMDR Buffer Full
- CPU-LAN link Error
• The SL2100 does not support printouts of the following Alarms:
- Power Failure
- RAM Backup Battery Error
- Networking Keep Alive Error
• Up to 12 System Alarm times can be scheduled to print on a Monthly, Daily, and Hourly time frame.
The report indicates both Major and Minor Alarms.
• When using the E-mail functionality of reports, the E-mail address in PRG 90-11-10 (From Address)
must be set for the E-mail feature to work.
SL2100
ISSUE 1.0
1-28
Alarm Reports
A
To Next Page
Loading...
