Voice/Melody Ringing by VM
Description
The Voice/Melody Ringing feature will play a pre-recorded WAV file (voice or melodies…) instead of
ringing tone to indicate an incoming trunk call. The system can be configured to play a WAV file either
on a per Caller-ID or per extension basis which can be used to identify the incoming caller.
CID : 214-555-2000
CID : 206-441-4720
Caller “B”
Caller “A”
214-555-2000 : Melody 1
206-441-4720 : Melody 2
04-
xxxxxxxxxx
:
PSTN
Copy
Voice/Music
Audio Prompt Format
In order for uploaded greetings to properly play on the SL2100 they must be in the proper format.
Audio files not recorded in the proper format may not playback. The proper format is:
Table 1-70 WAV Format
Item Specification
Bit Rate 64 kbps
Sampling Size 8 bits
Channel 1 (Mono)
Sampling Rate 8 kHz
Audio Format CCITT A-law
Size 2 MB
Length 2 Min.
To upload the WAV file to the system please refer to InMail Upload Download Audio on page 1-466.
Conditions
• The feature basically work with Normal Trunk Incoming call, PBX, CES Incoming Call, DID/DISA/
VRS, DID/DDI and Dial-In in the Tie Line.
• The feature does not work for Internal Incoming Call, Virtual extension ring, Door Box ring, Callback,
Alarm, VRS Waiting Message incoming call.
• This feature is only supported on Digital Multiline Terminals. Analog and IP Phones do not support
this feature.
• If all the VRS channels are busy, the normal incoming ring tone takes place.
• The Multiline Terminal must be idle for this feature to work.
ISSUE 1.0
SL2100
Features and Specifications Manual 1-901
V
To Next Page
Loading...
