EasyManua.ls Logo

NEC SL2100 - Table 1-52 Keys for Entering Names

NEC SL2100
978 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Guide to Feature Programming
Program
No.
Program Name Input Data Default
11-11-22 Service Code Setup (for Setup/Entry Operation) -
Extension Name Programming
0~9,
*
, # Maximum of 8 digit 700
14-01-01 Basic Trunk Data Setup - Trunk Name Up to 12 characters Trunk Port Number 1 =
Name Line 001
Trunk Port Number 2 =
Name Line 002
:
Trunk Port Number 128
= Name Line 128
15-01-01 Basic Extension Data Setup - Extension Name Up to 12 Characters No Setting
20-09-02 Class of Service Options (Incoming Call Service)
- Caller ID Display
0 = Off
1 = On
COS 01 ~ 15 = 1
20-13-21 Class of Service Options (Supplementary Serv-
ice) - Extension Name
0 = Off
1 = On
COS 01 ~ 15 = 1
20-13-47 Class of Service Options (Supplementary Serv-
ice) - Station Number Display
0 = Off
1 = On
COS 01 ~ 15 = 1
20-13-48 Class of Service Options (Supplementary Serv-
ice) - Station Name Display
0 = Off
1 = On
COS 01 ~ 15 = 1
20-13-51 Class of Service Options (Supplementary Serv-
ice) - Number and Name appear in the Directory
0 = Off
1 = On
COS 01 ~ 15 = 1
Operation
Refer to Table 1-52 Keys for Entering Names on page 1-646 for and explanation for using the keypad
to enter names.
Table 1-52 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 0
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters: 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В
*
Enter characters:
*
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed - ex:
TOM). Pressing # again = Space. (In system programming mode, use the right ar-
row Softkey instead to accept and/or add a space.)
Clear/Back or DND (2W Digital/IP Multi-
line Terminal)
Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
SL2100 ISSUE 1.0
1-646
Name Storing
N

Table of Contents

Other manuals for NEC SL2100

Related product manuals