NEC SL2100 - Table 1-5 Keys for Entering Names

4. Press the STORE softkey. The display shows:
##: xxxxxxxxxxxxx
mm-dd hh:mm
STA Abb
## = List Number
xx = Caller ID number
mm-dd hh:mm = incoming date and time
STA = Store in Station Speed Dial bin.
ABB - Store in System Speed Dial bin.
5. Press the STA or ABB softkey. The display shows:
Store to ABB: COMMON
ENTER BIN
6. Dial the Speed Dial bin in which the number is to be stored. If you press Hold key, the next
available Speed Dial bin will be used. The display shows:
ABB XXXX
xxxxxxxxxxxxx
If all Speed Dial bins are used, the display shows “TABLE IS FULL”.
7. Press Hold key. The display shows:
ABB XXXX
-
8. Enter the name to be associated with the stored number.
Table 1-5 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 0
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters: 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В
*
Enter characters:
*
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed -
ex: TOM). Pressing # again = Space. (In system programming mode, use the
right arrow Softkey instead to accept and/or add a space.)
Clear/Back or DND (2W Digital/IP
Multiline Terminal)
Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
ISSUE 1.0 SL2100
Features and Specifications Manual 1-155
C