NEC SL2100 - 4.4.2 Answering an Intercom Call; 4.4.3 Picking up a Call for Other Extensions

3. If you hear “Please enter an Account Code,”(depending on system programming) and your
display shows ENTER ACCOUNT CODE.
• Dial
*
.
- OR -
Press your Account Code key (PRG 15-07-01 or SC 751: code 50).
• Dial your Account Code (3~16 digits, using 0~9 and #).
If Account Codes are hidden, each digit you dial shows an
*
on the telephone display.
• Dial
*
.
- OR -
Press your Account Code key (PRG 15-07-01 or SC 751: code 50).
To enter an Account Code for an incoming call:
This procedure is not available for Single Line Terminals.
1. Answer incoming call.
If Account Codes for Incoming Calls is disabled, the following steps dial digits out onto the connected
trunk.
2. Dial
*
.
3. Enter the Account Code (1~16 digits).
You can enter any code of the proper length.
4. Dial
*
.
To enter a Forced Account Code at a Single Line Terminal:
1. Access trunk for outside call.
You can access a trunk by dialing a code. Refer to Central Office Calls, Placing for more information.
With Forced Account Codes, you hear, “Please enter an Account Code.”(It depends on
programming).
2. Dial
*
.
3. Enter Account Code (3~16 digits).
4. Dial
*
.
5. Dial number you want to call.
SL2100 ISSUE 1.0
1-20
Account Code Forced/Verified/Unverified
A