NEC SL2100 - Page 529

Program
No.
Program Name Input Data Default
10-37-01 UPnP Setup - UPnP Mode 0 = Disable
1 = Enable
0
10-37-02 UPnP Setup - Retry Time 0, 60 ~ 3600
(1 ~ 59 cannot be input)
60
14-01-24 Basic Trunk Data Setup - Trunk-to-Trunk Outgo-
ing Caller ID through Mode
0 = Disable (Caller ID not forwar-
ded out.)
1 = Enable (Caller ID is forwar-
ded out.)
0
14-02-01 Analog Trunk Data Setup - Signaling Type (DP/
DTMF)
0 = Dial Pulse (10 PPS)
1 = Dial Pulse (20 PPS)
2 = DTMF
2
14-05-01 Trunk Group - Trunk Group Number Trunk Port 1 ~ 128 = Priority 1 ~
128
Refer to the Program-
ming Manual for the
default values.
14-12-01 SIP Register ID Setup for IP Trunk - Register ID 0 ~ 31 0
14-12-02 SIP Register ID Setup for IP Trunk - Pilot Regis-
ter ID
0 ~ 31 0
14-18-05 IP Trunk Data Setup - SIP Profile (SIP Trunk) 1 = Profile 1
2 = Profile 2
3 = Profile 3
4 = Profile 4
5 = Profile 5
6 = Profile 6
1
15-03-03 Single Line Telephone Basic Data Setup - Termi-
nal Type
0 = Normal
1 = Special
0
15-16-01 SIP Register ID Setup for Extension - Register ID None, 0 ~ 31
(SIP Profile:1-6)
No Setting
21-17-01 IP Trunk (SIP) Calling Party Number Setup for
Trunk -
Calling Party Number
Up to 16 digits
(1 ~ 0,
*
, #)
No Setting
21-19-01 IP Trunk (SIP) Calling Party Number Setup for
Extension - Calling Party Number
Up to 16 Digits
(1 ~ 0,
*
, #)
(SIP Profile:1-6)
No Setting
22-02-01 Incoming Call Trunk Setup - Trunk Service Type 0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = Tie Line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID (DDI) Mode Switching
0
44-02-01 Dial Analysis Table for ARS/F-Route Access - Di-
al
Up to eight digits
(Use line key 1 for a Don’t Care
digit, @)
No Setting
44-02-02 Dial Analysis Table for ARS/F-Route Access -
Service Type
0 = No setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table (F-
Route)
3 = Dial Extension Analyze Table
(Option)
0
44-02-03 Dial Analysis Table for ARS/F-Route Access -
Additional Data
1 = Delete Digit = 0 ~ 255 (255 =
Delete All Digits)
2 = 0 ~ 100 (0 = No Setting)
3 = Dial Extension Analyze Table
Number = 0 ~ 4 (0 = No Setting)
0
44-05-01 ARS/F-Route Table - Trunk Group Number 0 = No Setting
1 ~ 50 = Trunk Group
255 = Extension Call
0
ISSUE 1.0 SL2100
Features and Specifications Manual 1-515
I