System Availability
Terminals
Any Multiline Terminal
Required Component(s)
SL2100 MOBILE EXT-01 LIC
Related Features
Abbreviated Dialing/Speed Dial
Caller ID
Direct Inward Dialing (DID)
Direct Inward Line (DIL)
Station Message Detail Recording
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
Program
No.
Program Name Input Data Default
11-02-01 * Extension Numbering - Extension Number Dial (Up to 8 digits) Extension Port Num-
ber : Extension Number
001 ~ 064 : 101 ~ 164
065 ~ 128 : No Setting
11-13 Service Code Setup (for ACD) - Refer to Programming
Manual.
14-01-24 Trunk-to-Trunk Outgoing Caller ID through Mode 0 = Disable (No)
1 = Enable (Yes)
0
15-22-01 * Mobile Extension Setup - Mobile Extension Tar-
get Setup
0 = No Setting
1 ~ 999 = Speed Dial Bin 1 ~ 999
(PRG 13-04)
0
15-22-02 Mobile Extension Setup - Connect Confirmation 0 = Always (User must dial
when answered for the call to cut
through on ALL line types.)
1 = On Analog Line (User must
dial
when answered for the call
to cut through on Analog lines
only.)
2 = Never (When the call is an-
swered the call is immediately
cuts through.)
0
ISSUE 1.0 SL2100
Features and Specifications Manual 1-621
M
To Next Page
Loading...
