Conditions
• Without SDVM( ) Card, approximately two hours message storage can be recorded for VRS/VM
(InMail) in a flash memory on CPU board. This VRS prompt message can be used for HOLD
message.
Default Settings
Disabled
System Availability
Terminals
None
Required Component(s)
None
Related Features
Analog Communications Interface (ACI)
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
Program
No.
Program Name Input Data Default
10-04-01 * Music On Hold Setup - Music on Hold Source Se-
lection
0 = Internal MOH (Tone is fixed
by one music tone.)
1 = External MOH (Tone set by
PRG 10-60-01: Audio Port No.2)
2 = Service Tone (Tone set by
PRG 80-01, tone 64)
3 = VRS (Tone set by PRG
10-04-02)
0
10-04-02 Music On Hold Setup - Music on Hold Tone Se-
lection
[In case Item 1 is 3.]
1 ~ 100 = VRS Message Number
1
10-04-03 Music On Hold Setup - Audio Gain Setup 1 ~ 63 (- 15.5 ~ + 15.5 dB) 32 (0 dB)
14-08-01 Music on Hold Source for Trunks - MOH Type 0 = Internal/External MOH
1 = BGM Source
0
10-60-02 Audio Port Setup - Slot No. Slot Number = 0 ~ 12 0
22-11-09 DID Translation Table - Music on Hold Source 0 = MOH Tone
1 = BGM Source
0
ISSUE 1.0 SL2100
Features and Specifications Manual 1-643
M
To Next Page
Loading...
