NEC SL2100 - Page 708

Program
No.
Program Name Input Data Default
14-01-02 Basic Trunk Data Setup - Transmit Level 1 ~ 57
(-15.5 dB ~ +12.5 dB in 0.5 dB
intervals)
32 (0 dB)
14-01-08 Basic Trunk Data Setup - Toll Restriction 0 = Restriction Disabled (Toll re-
striction will not be applied to
calls on this trunk.)
1 = Restriction Enabled (Toll re-
striction will be applied to calls on
this trunk.)
1
14-02-01 Analog Trunk Data Setup - Signaling Type (DP/
DTMF)
0 = Dial Pulse (10 PPS)
2 = DTMF
2
14-02-02 Analog Trunk Data Setup - Ring Detect Type 0 = Normal/delayed
1 = Immediate Ringing
1
14-04-01 Behind PBX Setup - Type of Connection 0 = Stand Alone (Trunk)
1 = Behind PBX (PBX)
3 = CTX assume 9
0
21-04-01 Toll Restriction Class for Extensions - Restric-
tion Class
1 ~ 15 = Toll Class 1 ~ 15 2
21-05-12 Toll Restriction Class - PBX Call Restriction 0 = Disable (PBX/CTX call not
restricted.)
1 = Enable (PBX/CTX call re-
stricted.)
Class 1 ~ 6 = 0
Class 7 = 1
Class 8 ~ 15 = 0
21-06-08 Toll Restriction Table Data Setup - PBX Access
Code
Table 1 ~ 4 = No Set-
ting
Operation
To place a call over a PBX trunk:
1. At Multiline Terminal, press Speaker key and dial 704.
- OR -
At Single Line Terminal, lift the handset and dial 704.
2. Dial PBX trunk group number (01 ~ 50).
3. Dial PBX access code and number.
- OR -
1. At the Multiline Terminal only, press the PBX trunk group key (PRG 15-07 or SC 752:
*
02 +
group).
2. Dial PBX access code and number.
- OR -
1. At the Multiline Terminal, press Speaker key and dial 0 .
- OR -
At the Single Line Terminal, lift the handset and dial 0 .
2. Dial the PBX access code and number.
- OR -
1. At the Multiline Terminal, press Speaker key.
- OR -
At the Single Line Terminal, lift the handset.
2. Dial #0.
3. Dial the PBX trunk number (e.g., 05 for line 5).
4. Dial the PBX access code and number.
SL2100
ISSUE 1.0
1-694
PBX Compatibility/Behind PBX
P