Use this keypad digit . . . When you want to. . .
9 Enter characters: W-Z, w-z, 9.
0 Enter characters: 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters:
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# Accepts a numeric entry from the user when setting a display message.
e.g., time or date. Back at ##:##
Clear/Back or DND (2W Digital/IP
Multiline Terminal)
Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
Operation
To select a message:
1. Press Speaker key.
2. Dial Text Message Service Code (by PRG 11-11-14) .
-OR-
Press the Text Message key (PRG 15-07 or SC 751: 18) + enter digits to append (if needed) +
press Speaker key to hang up. Skip the remaining steps.
3. Enter message number.
4. + enter digits to append (if needed) + press Speaker key to hang up. Skip the remaining steps.
5. (Optional for messages 1~8 and 10.)
Dial the digits you want to append to the message.
You can append messages 1~8 and 10 with digits (e.g., the time when you will be back). Enter the time
in 24-hour format.
6. Press Speaker key to hang up.
Intercom calls to extensions with Selectable Display Messaging set receive a DND signal and receive
the display message on their telephone display instead of ringing the extension based on the setting in
PRG 20-01-02.
To allow calls to ring through and have the message displayed on the calling extension display, cancel
DND by pressing DND key + dialing 0.
To cancel a message:
1. Press Speaker key and the Text Message key (PRG 15-07 or SC 751: 18).
2. Press Speaker key to hang up.
Using the Text Message Service Code to select a message:
1. Press Speaker key and dial the Text Message service code (PRG 11-11-14).
2. Dial the Selectable Display Message number to be used (01~20).
(Optional messages 1~8, and 10, dial the digits you want to append to the message.)
3. Press Speaker key to hang up.
To cancel, repeat step 1 and hang up.
SL2100 ISSUE 1.0
1-764
Selectable Display Messaging
S
To Next Page
Loading...
