Program
No.
Program Name Input Data Default
16-02-01 Department Group Assignment for Extensions - Refer to Programming
Manual.
16-03-01 Secondary Department Group - No Setting
20-06-01 Class of Service for Extensions - Class of Serv-
ice for Extensions
1 ~ 15 Extension 101 is Class
15 and other Extension
are Class 1
20-09-07 Class of Service Options (Incoming Call Service)
- Call Queuing
0 = Off (Calls are not queued.)
1 = On (Calls are queued.)
COS 01 ~ 15 = 0
20-11-17 Class of Service Options (Hold/Transfer Service)
- Department Group Trunk-to-Trunk Transfer
(Each Telephone Group Transfer)
0 = Off
1 = On
COS 01 ~ 15 = 1
20-13-06 Class of Service Options (Supplementary Serv-
ice) - Automatic Off-Hook Signaling (Automatic
Override)
0 = Off (manually)
1 = On (automatically)
COS 01 ~ 15 = 1
20-13-14 Class of Service Options (Supplementary Serv-
ice) - Department Calling (PLT No Called Exten-
sion)
0 = Off
1 = On
COS 01 ~ 15 = 1
22-02-01 Incoming Call Trunk Setup - Trunk Service Type 0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = Tie Line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID (DDI) Mode Switching
0
22-07-01 DIL Assignment - Number of Transferring Desti-
nation
Maximum of 8 digits (0 ~ 9,
, #) No Setting
24-02-05 System Options for Transfer - Message Wait
Ring Interval Time
0 ~ 64800 seconds 30
24-02-08 System Options for Transfer - Delayed Transfer
Time for all Department Groups
0 ~ 64800 seconds 10
24-05-01 Department Group Transfer Target Setup - Speed
Dial Area Number
0 ~ 999 999
Operation
To call a UCD Group:
1. At the Multiline Terminal, press Speaker key.
- OR -
At Single Line Terminal, lift the handset.
2. Dial the UCD group (department) extension or pilot number.
The system routes the call to the first free telephone in the (UCD group) department.
To log out of your UCD (Depatment Calling) Group:
While you are logged out, UCD (Department Calling) cannot route calls to your extension.
1. Press Speaker key.
SL2100
ISSUE 1.0
1-860
Uniform Call Distribution (UCD)
U
To Next Page
Loading...
