Program
No.
Program Name Input Data Default
15-03-01 Single Line Telephone Basic Data Setup - SLT
Signaling Type
0 = DP
1 = DTMF
1
15-03-03 Single Line Telephone Basic Data Setup - Termi-
nal Type
0 = Normal
1 = Special
0
15-03-09 Single Line Telephone Basic Data Setup - Caller
ID Function
0 = Disable (Caller ID not dis-
played.)
1 = Enable (Caller ID is dis-
played.)
1
15-03-16 Single Line Telephone Basic Data Setup - Spe-
cial DTMF Protocol Send
0 = No
1 = Yes
0
15-07-01 Programmable Function Keys - Refer to the program-
ming manual for the
default values and for
all other available op-
tions in this command.
16-01-01 Department Group Basic Data Setup - Depart-
ment Name
Maximum 12 characters No Setting
16-01-02 Department Group Basic Data Setup - Depart-
ment Calling Cycle
0 = Normal Routing (Priority)
1 = Easy - UCD Routing (Circu-
lar)
0
16-01-03 Department Group Basic Data Setup - Depart-
ment Routing when Busy (Auto Step Call)
0 = Normal (Intercom caller
hears busy tone.)
1 = Circular (Intercom caller
routes to an idle group member.)
0
16-01-04 Department Group Basic Data Setup - Hunting
Mode
0 = Stop at last member (non-
loop)
1 = Circular
0
16-01-05 Department Group Basic Data Setup - Extension
Group All Ring Mode Operation
0 = Manual (Ring the extensions
one at a time when the service
code are pressed.)
1 = Automatic (Ring all exten-
sions.)
0
16-01-06 Department Group Basic Data Setup - STG With-
draw Mode
0 = Disabled (Call will camp on
to the group.)
1 = Automatic (Call follows PRG
22-11-11.)
0
16-01-07 Department Group Basic Data Setup - Call Recall
Restriction for STG
0 = Disabled (Call will recall.)
1 = Enabled (Call will not recall.)
0
16-01-09 Department Group Basic Data Setup - Depart-
ment Hunting No Answer Time
0 ~ 64800 seconds 15
16-01-10 Department Group Basic Data Setup - Enhanced
Hunt Type
0 = No hunting
1 = Hunting When Busy
2 = Hunting When Not Answered
3 = Hunting When Busy or No
Answer
0
16-02-01 Department Group Assignment for Extensions - Refer to Programming
Manual.
20-02-09 System Options for Multiline Telephones - Dis-
connect Supervision
0 = Disable (Off)
1 = Enable (On)
1
20-03-01 System Options for Single Line Telephones - SLT
Call Waiting Answer Mode
0 = Hook Flash (Hooking)
1 = Hook Flash + Service Code
794
0
20-06-01 Class of Service for Extensions - Class of Serv-
ice for Extensions
1 ~ 15 Extension 101 is Class
15 and other Extension
are Class 1
20-11-01 Class of Service Options (Hold/Transfer Service)
- Call Forward All
0 = Off
1 = On
COS 01 ~ 15 = 1
ISSUE 1.0 SL2100
Features and Specifications Manual 1-891
V
To Next Page
Loading...
