After you finish
Go to
Complete battery replacement
.
Complete battery replacement
You complete a battery replacement by placing the controller online to confirm the new battery is
working correctly. Then, you can collect support data and resume operations.
Steps
1. Place controller online.
a. In System Manager, navigate to the hardware page.
b. Select Show back of controller.
c. Select the controller with the replaced battery.
d. Select Place online from the drop-down list.
2. As the controller boots, check the controller LEDs.
When communication with the other controller is reestablished:
• The amber Attention LED remains on.
• The Host Link LEDs might be on, blinking, or off, depending on the host interface.
3. When the controller is back online, confirm that its status is Optimal and check the controller
shelf’s Attention LEDs.
If the status is not Optimal or if any of the Attention LEDs are on, confirm that all cables are
correctly seated, and the controller canister is installed correctly. If necessary, remove and
reinstall the controller canister.
Note: If you cannot resolve the problem, contact technical support.
4. Click Support > Upgrade Center to ensure that the latest version of SANtricity OS is
installed.
As needed, install the latest version.
5. Verify that all volumes have been returned to the preferred owner.
a. Select Storage > Volumes. If current owner and preferred owner are not listed select All
volumes > Columns. Select current owner and preferred owner, and then recheck to verify
that volumes are distributed to their preferred owners.
b. If volumes are all owned by preferred owner continue to Step 6.
Maintaining EF300 and EF600 Hardware
11
Batteries
To Next Page
Loading...
Need help?
General
