NetApp E Series Maintaining

3.
If removed, install the SFPs into the new HIC and reconnect all the cables.
If you are using more than one host protocol, be sure to install the SFPs in the correct host
ports.
After you finish
Go to
Complete adding host interface card .
Reinstall the controller canister
You reinstall the controller canister into the controller shelf after installing the HIC.
Steps
1. Lower the cover on the controller canister and secure the thumbscrew.
2. While squeezing the controller handles, gently slide the controller canister all the way into the
controller shelf.
Note: The controller audibly clicks when correctly installed into the shelf.
3. If removed, install the SFPs into the new HIC and reconnect all the cables.
If you are using more than one host protocol, be sure to install the SFPs in the correct host
ports.
Maintaining EF300 and EF600 Hardware
55
Host interface cards

NetApp E Series Specifications

General

Form Factor	2U, 4U
Drive Types	SSD
Host Interface	SAS, iSCSI, FC, IB
RAID Levels	RAID 0, 1, 5, 6, 10
Operating System Compatibility	Windows, Linux, VMware
Management Software	SANtricity