4.
Locate the handle on the front of the power supply.
5.
Use the handle to slide the power supply straight out of the system.
Attention: When removing a power supply, always use two hands to support its weight.
After you finish
Go to
Install new power supply
.
Install new power supply and complete power supply replacement
You install a new power supply to replace the failed one. Install the power supply by gently sliding
it into the opening of the new controller. Then complete the power supply replacement by
confirming that the new power supply is working correctly.
Before you begin
• You have a replacement power supply that is supported for your controller shelf .
• You have unpacked the replacement power supply.
• You have removed the failed power supply.
Maintaining EF300 and EF600 Hardware
82
Power Supplies
To Next Page
Loading...
