NetApp E Series Maintaining

Complete protocol conversion
After you apply the feature pack key to convert the protocol you must configure the host to use the
appropriate protocol.
Step
Configure the host to use the appropriate protocol.
For step-by-step instructions on how to configure the host, see the guide appropriate for your
system:
Linux express configuration
VMware express configuration
Windows express configuration
Specific settings might vary. Check the NetApp Interoperability Matrix for specific instructions
and additional recommended settings for your solution.
After you finish
Your host protocol conversion is complete. You can resume normal operations.
Maintaining EF300 and EF600 Hardware 80
Host port protocol conversion

NetApp E Series Specifications

General

Form Factor	2U, 4U
Drive Types	SSD
Host Interface	SAS, iSCSI, FC, IB
RAID Levels	RAID 0, 1, 5, 6, 10
Operating System Compatibility	Windows, Linux, VMware
Management Software	SANtricity