Troubleshooting
196
N600 and AC750 WiFi DSL Modem Routers
Troubleshoot Your Network Using the Ping Utility
Most network devices and routers contain a ping utility that sends an echo request packet to
the designated device. The device then responds with an echo reply. You can easily
troubleshoot a network using the ping utility in your computer or workstation.
Test the LAN Path to Your Modem Router
You can ping the modem router from your computer to verify that the LAN path to your
modem router is set up correctly.
To ping the modem router from a Windows computer:
1. From the Windows taskbar, click the
Start button and select Run.
2. In the field provided, type ping followed by the IP address of the modem router, as in this
example:
ping 192.168.1.1
3. Click the OK button.
A message such as the following one displays:
Pinging <IP address> with 32 bytes of data
If the path is working, you see this message:
Reply from < IP address >: bytes=32 time=NN ms TTL=xxx
If the path is not working, you see this message:
Request timed out
If the path is not functioning correctly, one of the following problems might be occurring:
• W
rong physical connections
For a wired connection, make sure that the numbered LAN port LED is lit for the port to
which you are connected.
Check that the appropriate LEDs are on for your network devices. If your modem router
and computer are connected to a separate Ethernet switch, make sure that the link LEDs
are lit for the switch ports that are connected to your computer and modem router.
• Wrong network configuration
V
erify that the Ethernet card driver software and TCP/IP software are both installed and
configured on your computer.
V
erify that the IP address for your modem router and your computer are correct and that
the addresses are on the same subnet.
To Next Page
Loading...
Need help?
General
