USB Storage
71
N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition
Create a Network Folder
To create a network folder:
1. From the USB Storage (Advanced Settings) screen, click the Create a Network Folder
button to open the Create a Network Folder screen:
Access Method Network
Connection
Enabled by default, this allows all users on the LAN to have access
to the USB drive.
HTTP Disabled by default. If you enable this setting, you can type
http://readyshare to access the USB drive.
HTTP (via
Internet)
Disabled by default. If you enable this setting, remote users can type
http://readyshare to access the USB drive over the Internet.
FTP Disabled by default.
FTP (via
Internet)
Disabled by default. If you enable this setting, remote users can
access the USB drive through FTP over the Internet.
Available
Network Folders
Folder Name Full path of the used by the network folder.
Volume name Volume name from the storage device (either USB drive or HDD).
Total/Free
Space
The current utilization of the storage device.
Share Name • You can click the name shown, or you can type it into the address
field of your web browser.
• If Not Shared is shown, then the default share has been deleted,
and no other share for the root folder exists. Click the link to
change this setting.
Read and Write
Access
Shows the permissions and access controls on the network folder.
• All-no password allows all users to access the network folder.
• admin prompts you to enter the same password that you use to
log in to the wireless modem router main menu.
Table 10. USB Storage (Advanced Settings) (continued)
Fields Description