Advanced Configuration
79
N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition
9. Click Apply to save your configuration.
Note: If your ISP assigns a private WAN IP address such as 192.168.x.x
or 10.x.x.x, the Dynamic DNS service will not work because private
addresses are not routed on the Internet.
Configure LAN Settings
The LAN Setup screen allows configuration of LAN IP services such as DHCP.
Note: If you change the LAN IP address of the wireless modem router
while connected through the browser, you will be disconnected. You
need to then open a new connection to the new IP address and log
in again.
The wireless modem router is shipped preconfigured to use private IP addresses on the LAN
side and to act as a DHCP server. The wireless modem router’s default LAN IP configuration
is as follows:
• LAN IP address. 192.168.0.1
• Subnet mask. 255.255.255.0
These addresses are part of the Internet Engineering Task Force (IETF)–designated private
address range for use in private networks and should be suitable in most applications. If your
network has a requirement to use a different IP addressing scheme, you can make those
changes by opening the LAN Setup screen.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
