Table 4. Troubleshooting chart (Continued)
Possible SolutionPossible CauseSymptom
Break the loop by making sure that only one
path exists from any networked device to any
other networked device.
One possible cause is that a
broadcast storm occurred and that
a network loop (redundant path)
was created.
A file transfer is slow or the
performance is degraded.
Verify that the cabling is correct.
Make sure that all connectors are securely
positioned in the required ports. It is possible
that equipment was accidentally
disconnected.
One or more devices are not
properly connected, or cabling
does not meet Ethernet guidelines.
A segment or device is not
recognized as part of the
network.
Break the loop by making sure that only one
path exists from any networked device to any
other networked device.
A network loop (redundant path)
was created.
One or more port LEDs are
blinking continuously and the
network is disabled.
User Manual108Diagnostics and
Troubleshooting
Nighthawk SX10 Pro Gaming Advanced 8-Port Gigabit Ethernet Switch Model GS810EMX
To Next Page
Loading...
