NETGEAR Nighthawk SX10 Pro Gaming

9.
If the login page does not display, in the address field of your web browser, enter
the new IP address of the switch.
The login page displays.
10.
For easy access to the local browser interface, bookmark the page on your computer.
Set Up a Fixed IP Address for the Switch by Connecting
Directly to the Switch Off-Network
In the unlikely situation that the switch is not connected to a network, or for some reason
you cannot connect to the switch over a network connection, you can change the IP
address of the switch by using an Ethernet cable and making a direct connection to the
switch.
To disable the DHCP client of the switch and change the IP address of the switch
to a fixed IP address by using a direct connection:
1.
Connect an Ethernet cable from your computer to an Ethernet port on the switch.
2.
Change the IP address of your computer to be in the same subnet as the default IP
address of the switch.
The default IP address of the switch is 192.168.0.239. This means that you must
change the IP address of the computer to be on the same subnet as the default IP
address of the switch (192.168.0.x).
The method to change the IP address on your computer depends on the operating
system of your computer.
3.
Open a web browser from a computer that is connected to the switch directly through
an Ethernet cable.
4.
Enter 192.168.0.239 as the IP address of the switch.
The login page displays.
5. Enter the switch password.
The default password is password. The password is case-sensitive.
The HOME page displays.
6.
Below the SYSTEM INFO pane, select DHCP.
The button bar in the DHCP section displays green because the DHCP client of the
switch is enabled.
7. Click the button in the DHCP section.
The button bar displays gray, indicating that the DHCP client of the switch is disabled,
and the IP address fields become editable.
User Manual23Install and Access the Switch in
Your Network
Nighthawk SX10 Pro Gaming Advanced 8-Port Gigabit Ethernet Switch Model GS810EMX