NETGEAR Nighthawk SX10 Pro Gaming

The settings for the selected port become available.
6.
Select one of the following options from the Speed menu:
•
Auto. The port speed is set automatically after the switch determines the speed
using autonegotiation with the linked device.
•
10M Half. The port is forced to function at 10 Mbps with half-duplex.
This option is not available for ports 1 and 2.
•
10M Full. The port is forced to function at 10 Mbps with full-duplex.
This option is not available for ports 1 and 2.
•
100M Half. The port is forced to function at 100 Mbps with half-duplex.
This option is not available for ports 1 and 2.
•
100M Full. The port is forced to function at 100 Mbps with full-duplex.
Note: For ports 3 through 10, you cannot select Gigabit Ethernet as the port speed.
For ports 1 and 2, you cannot select 1G, 2.5G, 5G, or 10G as the port speed. However,
if the setting from the Speed menu is Auto, the switch can use autonegotiation to
automatically set the port speed to Gigabit Ethernet, or for ports 1 and 2, a higher
speed, if the linked device supports that speed.
7.
Click the APPLY button.
Your settings are saved and the port is reenabled.
Add or Change the Name Label for a Port
By default, only ports 1, 9, and 10 contain a port name label:
•
Port 1. Uplink
•
Port 9. Media Streaming
•
Port 10. Gaming
You can change these name labels. Other ports do not contain name labels, but you
can add them. Adding or changing a name label does not change the nature of a port,
that is, it is just a label.
To add or change a name label for a port:
1.
Open a web browser from a computer that is connected to the same network as the
switch or to the switch directly through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
The login page displays.
User Manual47Optimize the Switch
Performance
Nighthawk SX10 Pro Gaming Advanced 8-Port Gigabit Ethernet Switch Model GS810EMX