NETGEAR Nighthawk SX10 Pro Gaming

3. Enter the switch password.
The default password is password. The password is case-sensitive.
The HOME page displays.
4.
In the SYSTEM INFO pane, select LED.
By default, the PORT ACTIVITY LEDS tab is selected and the ACTIVITY LEDs page
displays.
5.
At the bottom of the page, click the RESET TO DEFAULT link.
A pop-up warning window opens.
6.
Click the CONTINUE button.
The pop-up window closes. The port LEDs are reset to default settings.
Manage the Power LED
The switch lets you manage the activity (enabled or disabled) and color of the Power
LED on the top of the switch.
To manage the Power LED:
1.
Open a web browser from a computer that is connected to the same network as the
switch or to the switch directly through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
The login page displays.
3. Enter the switch password.
The default password is password. The password is case-sensitive.
The HOME page displays.
4.
Below the SYSTEM INFO pane, select LED.
By default, the PORT ACTIVITY LEDS tab is selected and the ACTIVITY LEDs page
displays.
5.
Click the POWER LED tab.
The POWER LED page displays.
6.
Specify the following settings:
•
Activity. By default, the Power LED lights when you apply power to the switch.
To disable the Power LED, click the Enable Power LED button.
When the LED activity is enabled, the button bar display green. When it is
disabled, the button bar displays white.
User Manual98Maintain and Monitor the Switch
Nighthawk SX10 Pro Gaming Advanced 8-Port Gigabit Ethernet Switch Model GS810EMX