NETGEAR Nighthawk SX10 Pro Gaming

The login page displays.
3. Enter the switch password.
The default password is password. The password is case-sensitive.
The HOME page displays.
4.
From the menu at the top of the page, select SWITCHING.
The QOS page displays.
5.
From the menu on the left, select MULTICAST.
The MULTICAST page displays.
6.
From the menu in the IGMP Snooping Static Router Port section, select a specific
port as the router port or select Any to let IGMP Join and Leave messages be sent
to every port on the switch.
Typically, the uplink port (that is, the port that is connected to your router or to the
device that provides your Internet connection) serves as the router port.
7.
Click the APPLY button.
Your settings are saved.
Set Up Link Aggregation
The switch supports both static link aggregation groups (also referred to as port trunking
groups) and Link Aggregation Control Protocol (LACP) groups through IEEE 802.3ad
Link Aggregation. A link aggregation group (LAG) lets you to combine multiple Ethernet
ports into a single logical link. Your network devices treat the aggregation as if it were
a single link. Depending on how link aggregation is set up in your network, the link
supports either increased bandwidth (a larger pipe) or fault tolerance (if one port fails,
another one takes over).
The switch supports four LAGs. If you use ports 1 and 2 with 10G connections, you can
set up a LAG that supports up to 20 Gbps. Configure LAG membership before you
enable the LAG.
You set up link aggregation on the switch through a LAG in the following order:
1. Set up the LAG on the switch (see Set Up a Link Aggregation Group on page 81).
2.
Connect the ports that must be members of the LAG on the switch to the ports that
must be members of the LAG on another device in your network (see Make a Link
Aggregation Connection on page 82).
User Manual80Manage the Switch in Your
Network
Nighthawk SX10 Pro Gaming Advanced 8-Port Gigabit Ethernet Switch Model GS810EMX