NETGEAR Nighthawk SX10 Pro Gaming

3. Enter the switch password.
The default password is password. The password is case-sensitive.
The HOME page displays.
4.
From the menu at the top of the page, select SETTINGS.
The PRESET MODES page displays.
5.
From the menu on the left, select ACCESS CONTROL.
The ACCESS CONTROL page displays.
6. Click the IP address that you want to remove.
The DELETE button displays.
7.
Click the DELETE button.
The IP address is removed and can no longer access the local browser interface of
the switch.
8. To remove more IP addresses, repeat the previous step.
If you remove all IP addresses, all access restrictions are lifted and any IP address
can access the local browser interface of the switch.
Manage the Power Saving Mode
The power saving mode enables the IEEE 802.3az Energy Efficient Ethernet (EEE)
function, cable length power saving, and link-up and link-down power saving:
•
IEEE 802.3az. Combines the Energy Efficient Ethernet (EEE) 802.3 MAC sublayer
with the 100BASE-TX, 1000BASE-T, and 10GBASE-T physical layers to support
operation in Low Power Idle (LPI) mode. When LPI mode is enabled, systems on
both sides of the link can disable portions of their functionality and save power during
periods of low link utilization.
•
Short cable power saving. Dynamically detects and adjusts power that is required
for the detected cable length.
•
Link-down power saving. Reduces the power consumption considerably when the
network cable is disconnected. When the network cable is reconnected, the switch
detects an incoming signal and restores normal power.
By default, the power saving mode is disabled.
User Manual93Maintain and Monitor the Switch
Nighthawk SX10 Pro Gaming Advanced 8-Port Gigabit Ethernet Switch Model GS810EMX