FS728TP Smart Switch Software User Manual
Configuring the Device Using Your Browser 5-112
v2.0, November 2006
– SNMPv3 Notification Recipient
SNMPv1, 2c Notification Recipient
The SNMP v1, v2c Recipient table contains the following fields:
– ID – Indicates the SNMP table entry number.
– Recipients IP – Displays the IP address to which the traps are sent.
– Notification Type – Displays the notification sent. The possible field values are:
– Trap – Indicates traps are sent.
– Inform – Indicates informs are sent.
– Community String – Displays the community string of the trap manager.
– Notification Version – Displays the trap type. The possible field values are:
– SNMP V1 – Indicates that SNMP Version 1 traps are sent.
– SNMP V2c – Indicates that SNMP Version 2 traps are sent.
– UDP Port – Displays the UDP port used to send notifications. The default is 162.
– Filter Name – Indicates if the SNMP filter for which the SNMP Notification filter is
defined.
– Timeout – Indicates the amount of time (in seconds) the device waits before re-sending
informs. The default is 15 seconds.
– Retries – Indicates the amount of times the device re-sends an inform request. The default
is 3 seconds.
– Delete – Removes the currently selected recipient. The possible field values are:
– Checked – Removes the selected recipient from the list of recipients.
– Unchecked – Maintains the list of recipients.
SNMPv3 Notification Recipient
The SNMPv3 Notification Recipient table contains the following fields:
– ID – Indicates the SNMP table entry number.
– Recipient IP – Displays the IP address to which the traps are sent.
– Notification Type – Displays the type of notification sent. The possible field values are:
– Trap – Indicates that traps are sent.
To Next Page
Loading...
