Virtual Private Networking Using IPSec Connections
144
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Figure 83.
Note: When using FQDNs, if the Dynamic DNS service is slow to update
its servers when your DHCP WAN address changes, the VPN tunnel
will fail because the FQDNs do not resolve to your new address. If
you have the option to configure the update interval, set it to an
appropriately short time.
4. Optional step: Collect the information that you need to configure the VPN client. You can
print the following table to help you keep track of this information.
Use the NETGEAR VPN Client Wizard to Create a Secure Connection
The VPN client lets you set up the VPN connection manually (see Manually Create a Secure
Connection Using the NETGEAR VPN Client on page 149) or with the integrated
Configuration Wizard, which is the easier and preferred method. The Configuration Wizard
configures the default settings and provides basic interoperability so that the VPN client can
easily communicate with the VPN firewall (or third-party VPN devices). The Configuration
Wizard does not let you enter the local and remote IDs, so you need to manually enter this
information.
Table 31. Information required to configure the VPN client
Component Example Information to be collected
Pre-shared key I7!KL39dFG_8
Remote identifier information srx_remote.com
Local identifier information srx_local.com
Router’s LAN network IP address 192.168.1.0
Router’s LAN network mask 255.255.255.0
Router’s WAN IP address 10.34.116.22
To Next Page
Loading...
Need help?
General