Virtual Private Networking Using IPSec Connections
141
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Figure 80.
b. Locate the policy in the table, and click the Connect table button. The IPSec VPN
connection should become active.
Note: When using FQDNs, if the Dynamic DNS service is slow to update
its servers when your DHCP WAN address changes, the VPN tunnel
will fail because the FQDNs do not resolve to your new address. If
you have the option to configure the update interval, set it to an
appropriately short time.
Create a Client-to-Gateway VPN Tunnel
Figure 81.
To configure a VPN client tunnel, follow the steps in the following sections:
• Use the VPN Wizard Configure the Gateway for a Client Tunnel on page 142.
• Use the NETGEAR VPN Client Wizard to Create a Secure Connection on page 144 or
Manually Create a Secure Connection Using the NETGEAR VPN Client on page 149.
To Next Page
Loading...
Need help?
General