NETGEAR SRX5308 User Manual

Introduction
15
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
The front panel also contains three groups of status indicator light-emitting diodes (LEDs),
including Power and Test LEDs, LAN LEDs, and WAN LEDs, all of which are explained in the
following table.
Figure 1.
Table 1. LED descriptions
LED Activity Description
Power On (green) Power is supplied to the VPN firewall.
Off Power is not supplied to the VPN firewall.
Test On (amber) during
startup.
Test mode: The VPN firewall is initializing. After approximately
2 minutes, when the VPN firewall has completed its initialization, the
Test LED goes off.
On (amber) during
any other time
The initialization has failed, or a hardware failure has occurred.
Blinking (amber) The VPN firewall is writing to flash memory (during upgrading or
resetting to defaults).
Off The system has booted successfully.
LAN Ports
Left LED On (green) The LAN port has detected a link with a connected Ethernet device.
Blinking (green) Data is being transmitted or received by the LAN port.
Off The LAN port has no link.
Right LED On (green) The LAN port is operating at 1000 Mbps.
On (amber) The LAN port is operating at 100 Mbps.
Off The LAN port is operating at 10 Mbps.
Power LED
Test LED
Left LAN LEDs
Right LAN LEDs
DMZ LED
Left WAN LEDs
Right WAN LEDs
LEDs
Internet

NETGEAR SRX5308 Specifications

General

Brand	NETGEAR
Model	SRX5308
Category	Firewall
Language	English