NETGEAR SRX5308 - Page 264

Network and System Management
264
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
3. Click Apply to save your settings.
Note: If you select the default NTP servers or if you enter a custom server
FQDN, the VPN firewall determines the IP address of the NTP
server by performing a DNS lookup. You need to configure a DNS
server address on a WAN ISP Settings screen (see Manually
Configure the Internet Connection on page 28) before the VPN
firewall can perform this lookup.
NTP Server (default or
custom)
From the drop-down list, select an NTP server:
• Use Default NTP Servers. The VPN firewall’s RTC is updated regularly by
contacting a default NETGEAR NTP server on the Internet.
• Use Custom NTP Servers. The VPN firewall’s RTC is updated regularly by
contacting one of the two NTP servers (primary and backup), both of which
you need to specify in the fields that become available with this menu
selection.
Note: If you select this option but leave either the Server 1 or Server 2 field
blank, both fields are set to the default NETGEAR NTP servers.
Note: A list of public NTP servers is available at
support.ntp.org/bin/view/Servers/WebHome.
Server 1 Name / IP
Address
Enter the IP address or host name of the primary NTP
server.
Server 2 Name / IP
Address
Enter the IP address or host name of the backup NTP
server.
Table 64. Time Zone screen settings (continued)
Setting Description