System Logs and Error Messages
331
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
• PPTP Idle Timeout Logs
Explanation Message 1: PPPoE connection started.
Message 2: Message from PPPoE server for correct login.
Message 3: Authentication for PPP succeeded.
Message 4: Local IP address assigned by the server.
Message 5: Server side IP address.
Message 6: The primary DNS server that is configured on the WAN ISP
Settings screen.
Message 7: The secondary DNS server that is configured on the WAN ISP
Settings screen.
Message 8: The PPP link has transitioned to idle mode. This event occurs
if there is no traffic from the LAN network.
Message 9: The time in minutes for which the link has been up.
Message 10: Data sent and received at the LAN side while the link was up.
Message 11: PPP connection terminated after idle time-out.
Recommended action To reconnect during idle mode, initiate traffic from the LAN side.
Table 94. System logs: WAN status, PPTP idle time-out
Message Nov 29 11:19:02 [SRX5308] [pppd] Starting connection
Nov 29 11:19:05 [SRX5308] [pppd] CHAP authentication succeeded
Nov 29 11:19:05 [SRX5308] [pppd] local IP address 192.168.200.214
Nov 29 11:19:05 [SRX5308] [pppd] remote IP address 192.168.200.1
Nov 29 11:19:05 [SRX5308] [pppd] primary DNS address 202.153.32.2
Nov 29 11:19:05 [SRX5308] [pppd] secondary DNS address 202.153.32.2
Nov 29 11:20:45 [SRX5308] [pppd] No response to 10 echo-requests
Nov 29 11:20:45 [SRX5308] [pppd] Serial link appears to be disconnected.
Nov 29 11:20:45 [SRX5308] [pppd] Connect time 1.7 minutes.
Nov 29 11:20:45 [SRX5308] [pppd] Sent 520 bytes, received 80 bytes.
Nov 29 11:20:51 [SRX5308] [pppd] Connection terminated.
Explanation Message 1: Starting PPP connection process.
Message 2: Message from the server for authentication success.
Message 3: Local IP address assigned by the server.
Message 4: Server side IP address.
Message 6: The primary DNS server that is configured on the WAN ISP
Settings screen.
Message 7: The secondary DNS server that is configured on the WAN ISP
Settings screen.
Message 7: Sensing idle link.
Message 8: Idle link sensed.
Message 9: Data sent and received at the LAN side while the link was up.
Message 10: PPP connection terminated after idle time-out.
Recommended action To reconnect during idle mode, initiate traffic from the LAN side.
Table 93. System logs: WAN status, PPPoE idle time-out (continued)
To Next Page
Loading...
