21
Presets
1/2
Out
1
In
If you add an amp and cab rst but need to add an overdrive pedal
in front after, repositioning everything is as simple as dragging-
and-dropping the blocks into the order you require. Once you have
added a block to The Grid, tap it to open its menu.
Build a virtual rig from left to right. While it’s important to
remember how you might approach building a signal chain with
analog components, dragging-and-dropping a block after you’ve
added it to The Grid is effortless.
From here, several controls are available to you. Footswitches
will light up and correspond to any rotary controls on the block
you’ve added. Parameters such as gain can be controlled either by
rotating the footswitch or interacting with the screen.
To Next Page
Loading...