Nice SHEL60KIT

11 – DELETING DATA FROM THE CONTROL UNIT MEMORY
Data in the control unit memory can be deleted partially or totally as required.
To do this, the following procedures can be used, as required:
• Deletion of a command on a transmitter already memorised
• Deletion of other data memorised on the control unit
Deleting a command on a transmitter already memorised
The following procedure enables deletion of a single command assigned to a
transmitter key from the control unit memory.
Note – During the procedure, the red and green leds remain permanently lit.
01. Press and hold the key “P1” on the Control unit for at least 10 seconds:
the greenLedilluminatesrst,thenthered led illuminates after 5 seconds
and then both, to indicate that the Control unit has entered memory dele-
tionmode(WARNING! do not release the key P1!).
02. Without releasing key P1 press the transmitter key to be deleted: if the
control unit recognises this operation, the greenledemitsashortash,
after which the P1 key and transmitter key can be released.
Deleting other data memorised on the control unit
The following procedure enables deletion of various types of memorised data
from the control unit memory,asspeciedinTable 5.
Note – During the procedure, the red and green leds remain permanently lit.
01. Press and hold the key “P1” on the Control unit for at least 10 seconds:
the greenLedilluminatesrst,thenthered led illuminates after 5 seconds
and then both, to indicate that the Control unit has entered memory dele-
tion mode. Then release the key.
02. With reference to Table 5, select the data to be deleted and press P1 the
samenumberoftimesasthenumberofpressesspeciedinbrackets(the
green led emits one ash each time the P1 key is pressed).
03. 5 seconds after the key “P1” is pressed for the last time, if deletion is suc-
cessful,bothleds(redandgreen)ashquickly(= memory deleted!).
Note – Before deletion, there is a margin time of 5 seconds, in which the
user has the option to change decision and exit the procedure without
deleting data by pressing key P1 ve times.
IMPORTANT! - After deletion of the “Memory of Closing and Opening limit
positions” and “TOTAL Memory”, the procedure 9.2 – “Learning the Closing
and Opening limit positions” must be repeated.
TABLE 4
AUTOMATIC CLOSURE
Noclosure—>(presskey“T1”)
Closureafter15seconds—>(presskey“T2”)
Closureafter30seconds—>(presskey“T3”)
Closureafter60seconds—>(presskey“T4”)
MOVEMENT SPEED
Low Opening / Lowclosing—>(presskey“T1”)
Low Opening / Fastclosing—>(presskey“T2”)
Fast Opening / Lowclosing—>(presskey“T3”)
Fast Opening / Fastclosing—>(presskey“T4”)
SENSITIVITY TO OBSTACLES
High—>(presskey“T1”)
Medium high —>(presskey“T2”)
Medium low—>(presskey“T3”)
Low—>(presskey“T4”)
PRESSURE DISCHARGE
No discharge—>(presskey“T1”)
Minimum—>(presskey“T2”)
Medium—>(presskey“T3”)
Maximum—>(presskey“T4”)
TABLE 5
•MemoryofOptionalFunctionvalues(=1 press)
• Memory of “Closing ” and “Opening”limitpositions(=2 presses)
•MemoryofTransmitters(=3 presses)
• TOTAL memory (=4 presses) Note – deletes the rst three memories
in one process
English – 7
EN