Station Application:
KTS
Operation:
To use Automatic Repeat Dialling:
1. Place outside call.
− Listen for busy tone or ring-no-answer
2. Press OPAC key
3. Dial 1
4. Replace handset or press SPK key
− The system periodically redials the call.
To cancel Automatic Repeat Dialling:
1. Lifting the handset cancels Automatic Repeat Dialling
To use Hurry-Up operation:
1. Press OPAC key
2. Dial 2
Repeat Dialling and Hurry-Up Operation can be stored under One-Touch key.
On TX-Z 208 system, One-Touch Key No.99 is initially set as Automatic Repeat Dial key.
Related System Data:
#01-C: Queuing Group – Line Assignment
#33: LND/Repeat Dialling Hooking Time
#34: Repeat Dial Timers
Loop Key Trunk Access
Description:
User can assign only one Loop Key to one undefined Line keys. The Loop Key should
be assigned on an unused Line key in advance by using “one-Touch Feature Access”. This
feature permits access to an outgoing line by pressing a Loop Key. The trunk line is seized
from small number, large number, or rotated number. This key provides user advantage as
follows:
− When the number of Trunk lines connected to the system is larger than the number of
Line Keys at user’s KTS, user can seize all the Trunk line by pressing the Loop Key.
− User can use the Park Hold effectively.
There are 6 types of LED indication.
− System Hold: 0.1 sec On/ 0.1 sec Off (BLF: Green)
− Exclusive Hold: 0.1 sec On/ 0.1 sec Off/ 0.1 sec On/ 0.7 sec Off (BLF: Green)
− I-Use: Light (BLF: Green)
To Next Page
Loading...