Operation:
<KTS>
1. Lift handset (See note 1).
2. Dial # (TX-Z 824/1232/2464).
3. Dial Hunting Group number (0-4).
− The first idle extension is called. If the extension does not answer in the pre-
programmed time, the system calls the next idle extension, or the next idle extension,
or the caller can dial # to call next idle extension.
<SLT on Dial Plan 1>
1. Lift handset.
2. Dial 7, and wait for dial tone.
3. Dial #.
4. Dial Hunting Group number (0-4).
− The first idle extension is called. The extension does not answer in the pre-
programmed time, the system calls the next idle extensions, or the caller can dial # to
call the next idle extension.
Note 1: If Program #75-D is 0 (No Tone), press ICM key after step 1 to seize intercom
(TX-Z 824/1232/2464).
Note 2: SLT on Dial Plan 2 can not use this feature.
Note 3: When Program #80-2-A = 1, the extension of the first order number is called after
the extension of the last order number is called first. If the Hunting Group calling timer expires,
Group Hunt is used again, or Step Call (pressing #) is used.
Related System Dial:
#11: Hunting Group
#84: Hunting Group Calling Timer
#80-2A: Group Hunt Mode
Step Calling
Description:
When an extension user makes an Internal call and receives a busy signal or no answer,
Step Calling lets the user call the other extensions, in ascending order, by just dialling a code.
For example, if extension 12 is busy, Step Calling tries extension 13. If there is no answer at
extension 13, Step Calling tries extension 14, and so on. Step Calling is cancelled if it reaches
an extension that is not installed.
Station Application:
KTS, SLT
To Next Page
Loading...