Direct Station Selection
Description:
Direct Station Selection (DSS) provides an extension user with one-button access to
other extensions in the system. Each of the ten One-Touch keys on a key telephone can be
programmed to call a particular extension. The One-Touch keys can also be programmed to
access any Page Zone (See Paging) or Doorphone using the steps below.
Station Application:
KTS
Operation:
To program a One-Touch key for DSS:
1. Lift handset.
2. Press ICM key (TX-Z 824/1232/2464 only) (See note).
3. Press DC.
4. Dial #.
5. Press One-Touch key.
6. Dial extension number.
Or
To program a Page Zone, dial 80-87 (80-85 for TX-Z 308).
To program a Doorphone, dial 88 or 89.
7. To program more keys, repeat steps 3-6.
8. Hang up.
Note: If program is #75-D (No Tone) skip step 2 (TX-Z 824/1232/2464).
To use a DSS key:
1. Lift handset. If Single Step Access is programmed and the phone is equipped with a
speakerphone, this step can be skipped.
2. Press One-Touch key set as DSS key.
To hold and transfer a Trunk call using a DSS key:
− Make conversation with outside party.
1. Press a desired One-Touch key set as DSS key.
− The Trunk line will automatically be held, then intercom call will be established.
2. Make announcement (if desired).
3. Press TRFR key or hang up to transfer.
To Next Page
Loading...