Nitsuko TX Series - Volume Control; DLS Console (TX-Z 824;1232;2464)

 Volume Control
Description:
The Volume Control, which is provided with all KTS, allows easy changes to the
following: LCD contrast on KTS with LCD, station ringing volume, handset receiver volume,
and station speaker volume control.
Station Application:
KTS
Operation:
To adjust LCD contrast for KTS with LCD:
− Do not lift handset.
1. Press the Vol (up) or Vol (down) to increase/decrease LCD contrast while the phone is
handsfree mode.
To adjust Speaker Volume:
1. Press the Vol (up) or Vol (down) to increase/decrease speaker volume while the phone
is handsfree mode.
To adjust Handset Receiver Volume:
1. Press the Vol (up) or Vol (down) to increase/decrease handset receiver volume.
To adjust Ringing Volume:
1. Press the Vol (up) or Vol (down) to increase/decrease ringing volume while the phone
is ringing or idle mode.
Related System Data:
#18-D: Handset Receiver Volume
 DLS Console (TX-Z 824/1232/2464)
Description:
DLS (Direct Line Selection) Console has 24 DLS keys. Each DLS key is assigned as
Trunk Line or Feature Access key. DLS Console should be connected to KTS with LCD
extension.
On the TX-Z 824 System, this DLS Console is used as DSS (Direct Station Selection) Console.
Each DLS key is assigned to physical port number accordingly. (Not by extension number
which is set in Program 14). DLS Console user can call the other extension only pressing
DLS key. TX-Z 824 System can connect Maximum 3 DLS Consoles.
On the TX-Z 1232/2464 System, Each DLS Console key can be used as Trunk Line or Feature
Access key. Each DLS key is assigned from Trunk Line number 1 to Trunk Line number 24 on
the initial condition. DLS Console user can assign the unused DLS keys as feature Access key.