Nitsuko TX Series - Page 93

13: External Call Forward Mode (DISA) [OPAC-70]
14: Loop Key [None]
22: Conversation Record (TX-Z 824) [CONF-95]
23: Conversation Record (TX-Z 1232/2464) [CONF-95]
24: DSS Console Business Mode (TX-Z 1232/2464) [SPK-ICM-OPAC-74]
25: DSS Console Room Status Mode (TX-Z 1232/2464) [SPK-ICM-OPAC-74]
26: DSS Console Wakeup Mode (TX-Z 1232/2464) [SPK-ICM-OPAC-75]
Note: If Program #75-D is 0 (No Tone), skip pressing ICM (TX-824/1232/2464).
Station Application:
KTS
Operation:
To store a feature under a One-Touch or Line key:
1. Press SPK.
2. Press ICM key (TX-Z 824/1232/2464 only) (See Note 1).
3. Press OPAC, dial 4.
4. Press a desired One-Touch or Line key.
5. Dial feature number (01-14).
6. Dial 
7. Press SPK.
To clear a feature stored on a One-Touch or Line key:
1. Press SPK.
2. Press ICM key (TX-Z 824/1232/2464 only) (See Note 1).
3. Press OPAC, dial 4.
4. Press a One-Touch or Line key stored feature.
5. Dial 00 to delete a feature stored.
6. Dial 
7. Press SPK.
To check a feature store under One-Touch or Line key:
− Do not press SPK key.
1. Press CHECK.
2. Press a One-Touch or Line key stored feature.
3. The number set feature display.
Note 1: If Program #75-D is 0 (No Tone), skip pressing ICM (TX-Z 824/1232/2464).
Note 2: One-Touch key No.9 (TX-Z 308) is set as Repeat Dial key initially. To store another
feature, clear the feature first.
Related System Data:
Not applicable