Nitsuko TX Series - Night Service (Manual;Auto)

 Night Service (Manual/Auto)
Description:
Night Service puts the night audible (ringing) assignment (Program #7) into effect
manually or automatically. Incoming calls on a specific line group will ring at extensions that
are assigned night audible for that line group. Night Service remains set even if the system
power is turned off.
Night Service is available on a system basis or incoming line group basis according to Program
#15-B.
1. Night audible assignments go into effect at all extensions in the system. Day audible
assignments are ignored. The extension #10 can activate this Night Service (NT) mode
unless DSS Console is connected.
On the TX-Z 1232/2464 System, Night Service assignment can be activated by the DSS
Console. If DSS Console is not connected, the extension #10 can activate this mode
assignment.
2. Night audible assignments go into effect for the extensions that have the same primary
incoming line group as the extension that activates the NT mode. Extensions with a
different primary incoming line group receive ringing according to their day audible
assignments. Any extension can activate this mode.
This NT mode can be activated by any extension in each came primary incoming line
group.
Automatic Mode Switching
Automatic Mode Switching (Program #79) allows to switch Day/Night mode according
to pre-programmed time routine for the system. When automatic Mode Switching places the
system in Night Mode, TRFR blinks red at all key telephones. If the system mode is switched
manually at No.10 telephone or DSS, it overrides Automatic Mode Switching assignment.
Station Application:
KTS, SLT, External Speaker, Doorphone
Operation:
To activate Night Service:
<KTS>
1. Press SPK key.
2. Press ICM key (824/1232/2464 only) (See note)
3. Press TRFR key.
4. Dial # TRFR lights red.
5. Hang up.
To activate Night Service:
<DSS>
1. Press NT key (LED lights red).