Nitsuko TX Series - Intercom Call Transfer

To retrieve an intercom call on Hold:
1. Press ICM key.
Related System Data:
Not applicable
 Intercom Call Transfer
Description:
Intercom calls may be transferred to any extension manually.
There are two methods of transferring intercom calls.
Station Application:
KTS, SLT
Operation:
<KTS>
A. To make an Intercom Call Transfer using Intercom Hold:
1. Intercom call between A and B.
2. Press Hold key to put B on Hold.
3. Extension C dials extension number of A (TX-Z 824/1232/2464)
Extension C dials  and extension number of A (TX-Z 308).
− If extension C is SLT, dial access code 08 or 98 then dial extension number of A
(See Note).
4. Intercom call between B and C is established.
Note:
Program #20-D Data Automatic Trunk Access Code for SLT Dial at Step 3
0 0 98
1 9 08
<KTS, SLT>
B. To make an Intercom Call Transfer using Internal Conference (See Conference)
1. Intercom call between A and B.
2. Establish an Internal Conference with C.
3. Extension A hangs up.
Related System Data:
Not applicable