To activate or cancel Room Monitor at the monitoring extension:
− Do not lift handset.
1. Press OPAC.
2. Press FLASH.
− MON flashes intermittently on TD/TXD type telephone while Room Monitor is
activated.
− MIC flashes intermittently on BTD/BTXD type telephone while Room Monitor is
activated.
This feature can be stored under the One-touch key.
Related System Data:
#19-D: Room Monitor
DSS Console (TX-Z 1232/2464)
Description:
DSS Console gives an extension user a Busy Lamp Field (Idle/Busy/DND/MW) and
one-button access to extension, Doorphone or Paging. This saves time for users that do a lot of
processing (e.g. Operator). TX-Z 1232 System can connect one DSS Console. TX-Z 2464
System can connect Maximum 2 DSS Consoles. Pair extension of each DSS Console is
assigned in Program. When a DSS Console is connected, an intercom link is used exclusively
for DSS Console. The Pair extension must be KTS. (It is recommended to be KTS with LCD).
Each DSS Console must be connected to the LAST PORT of each unit.
DSS Console feature and operations are as follows:
1. DSS Call (One-Touch Extension Access)
Description:
User can make intercom conversation by only pressing the DSS key. Each DSS key is
assigned following extension number (which is set the in Program 14) accordingly. (Not
by physical port) Pair extension operated DSS Call can not use CONF, TRFR, HOLD
keys within intercom conversation.
Operation:
1) On the Trunk Line call.
2) Press one of DSS key.
Related System Data:
Intercom Calls
Flexible Station Numbering
To Next Page
Loading...