Recall Trunk Display
Description:
Executive telephone can be set to the Recall Trunk Display Mode. When Hold Recall
tone is heard, the telephone will display the held Trunk line and the telephone number.
Station Application:
KTS with LCD
Operation:
To set/reset:
1. Press SPK key.
2. Press ICM key (824/1232/2464 only) (See note)
3. Press OPAC key.
4. Press Check key.
Note: If program #75-D is 0 (No Tone), skip step 2 (824/1232/2464)
Related System Data:
Not applicable.
Park Hold (TX-Z 824/1232/2464)
Description:
This feature permits transferring of a call placed on temporary hold on a Park Hold key.
It is used to transfer an outside call to KTS’ that do not appear under a key in order to answer a
call on that line. Park Hold key can be assigned on Line keys. The system has four Park Hold
groups. An extension can be assigned to only one Park Hold group. A line group can contain
any number of lines. An extension user can answer a call placed on Park Hold only if the
extension is in the same Park Hold group. If the line seized by loop key is put on Park Hold, the
loop key’s LED goes off, and an idle Trunk line can be seized by pressing the Loop key.
Station Application:
KTS
Operation:
To place a call on Park Hold:
− While on an outside call.
1. Press Park Hold key.
To answer a call on Park Hold:
1. Lift handset.
2. Press Park Hold Key.
To Next Page
Loading...