Attendant Reverting
Description:
When hold transfer is failed because the destination telephone did not answer and
returned back to originating telephone, then the originating telephone did not answer, the next
action is selected by system data (Program #19-E) as follows:
1) The cal will be cut off pre-set timer (Program #29) is over.
2) The call will be transferred to the Attendant telephone.
Attendant Telephone: TX-Z 1232/2464 The pair extension of DSS console,
extension No.10 or operator station of each tenant.
TX-Z 824 Extension No.10 or operator extension
of each tenant.
TX-Z 308 Extension No.10.
This timer (Program #29) will be activated as below condition.
1. Put an outside call on System Hold.
2. Announced Transfer Recall timer is released.
3. Unannounced Transfer Recall timer is released.
4. Exclusive Hold Recall timer is released.
Station Application:
KTS, SLT
Operation:
Not applicable.
Related System Data:
#08-D: Tenant Group
#19-E: SLT Hold Transferring
#29: Attendant Reverting
#52: Tenant Feature
#54: Tenant Attendant
#62: DSS Console Port Assignment
To Next Page
Loading...