Nitsuko TX Series - Trunk Outgoing Call; Specified Trunk Access

Trunk Outgoing Call
 Specified Trunk Access
Description:
Trunk (CO/PBX) lines can be group into a maximum of 30 groups. The line groups
assigned to each extension can be used for outgoing calls. Up to two outgoing line groups can
be assigned to an extension. An extension user can place outside calls on a particular line group
by pressing Line key or dialling line number.
Station Application:
KTS, SLT
Operation:
To make an outside call on a particular line:
<KTS>
When the trunk line appears under a Line key:
1. Lift handset or press SPK key.
2. Press a Line key. Hear dial tone.
3. Dial telephone number.
When the trunk line does not appear under a Line key:
1. Lift handset or press SPK key. (See note 1)
2. Dial 9 (824/1232/2464).
Dial 90 (308).
3. Dial two-digit line number. Hear dial tone.
4. Dial telephone number.
<SLT>
1. Lift handset. Listen for dial tone.
2. Dial 0 or 9 (See note 2).
3. Dial two-digit line number. Hear dial tone.
4. Dial telephone number.
Note: 1 If program #75-D is 0 (No Tone), press ICM key after step 1 to seize Intercom
(824/1232/2464).
Note: 2
Program #20-D Data Automatic Trunk Access Code for SLT Dial at Step 2
0 0 9
1 9 0
Note: 3 Easy Trunk Access, Queuing Group Access, Loop Key Trunk Access, Automatic Off-
Hook Trunk Access features provide other ways to access a Trunk Line.