Nitsuko TX Series - Intercom Call

 Intercom Call
Description:
Intercom Call allows extension-to-extension conversation. The system can be
programmed for one of two Intercom Signalling modes: ringing or voice announce. When
voice announce is programmed, an Intercom call signals the called extension with a beep (not
ringing). After the beep sounds, the caller can make a voice announcement over the speaker of
the called extension.
Regardless of the signalling mode programmed, an extension user can change it on a per
call basis. For example, a ringing Intercom call cab be changed to a voice announced call by
dialling a code.
Station Application:
KTS, SLT
Operation:
To place an Intercom call:
<KTS>
1. Lift handset or press SPK key (See note 1).
2. Dial extension number.
To convert a ringing call into a voice announced call, or vice versa, dial 1.
<SLT on Dial Plan 1>
1. Lift handset.
2. Dial 7, wait for dial tone.
3. Dial extension number.
To convert a ringing call into a voice announced call, or vice versa, dial 1.
<SLT on Dial Plan 2>
1. Lift handset.
2. Dial extension number.
To convert a ringing call into a voice announced call, or vice versa, dial 1.
Note 1: If program #75-D is 0 (No Tone), press ICM key after step 1 to seize intercom (TX-Z
824/1232/2464).
Note 2: Call Monitor, Speaker-phone and Single Step Access provides ways to place intercom
calls without lifting the handset.
Related System Data:
#19-B: Intercom Call Type
#75-D: Key Telephone Off-Hook Mode Selection