Operation:
1. Place Intercom call.
− Receive busy tone or no answer.
2. Dial #
− Next extension is automatically called. To call the next extension, dial # again.
Related System Data:
Not applicable.
Camp-On (Call-Back)
Description:
Instead of hanging up after calling a busy extension, Camp-On lets an extension user
dial a code and wait off-hook until the extension becomes available. As soon as the extension
becomes free, the call automatically goes through. Or, if the extension user hangs up after
dialling the code. Call-Back automatically redials a busy extension. When the busy extension
becomes free. Call-back signals (rings) the extension that activated it. When the Call-back
signal is answered, an intercom call is automatically placed to the previously busy extension.
Calls can be placed while waiting for the Call-back signal, and Call-back can be activated for
more than one busy extension at a time. Camp-On/Call-back cannot be activated by an
extension that is programmed for Automatic Intercom Off-Hook Signalling (Program #04-C).
Camp-On/Call-back can also be activated when a user calls a busy Hunting Group (See Group
Hunt).
Station Application:
KTS, SLT
Operation:
To activate Camp-On:
1. Place Intercom call. Hear busy tone.
2. Dial. Busy tone stops.
3. Do not hang up.
4. Wait for the call to go through. Ringing is heard as soon as the extension becomes free.
To activate Call-back:
1. Place Intercom call. Hear busy tone.
2. Dial. Busy tone stops. One beep sounds over the speaker as confirmation.
3. Hang up.
To answer the Call-back signal:
− The signal sounds like an Intercom ring, but the ICM key does not flash.
1. Lift handset. Extension is called.
To Next Page
Loading...