Nitsuko TX Series - Message Waiting

To cancel Call-back:
1. Lift handset to cancel Call-back before receiving the Call-back signal.
2. Hang up.
Related System Data:
Not applicable.
 Message Waiting
Description:
When an extension user makes an Intercom call and receives a busy signal or no answer.
Message Waiting lets this user leave a visual indication (flashing MW/Indicator light) at the
busy/unattended phone requesting a return call. An extension user can leave Message Waiting
indications at several different extensions.
Station Application:
KTS, SLT
Operation:
To leave a Message Waiting:
<KTS/SLT>
1. Place Intercom call. Busy or no answer.
2. Dial 0. MW/Indicator flashes intermittently as confirmation (KTS).
3. Hang up.
To call the extension that left a Message Waiting indication:
<KTS>
1. Seize intercom.
2. Dial  (TX-Z 824/1232/2464).
Dial 87 (TX-Z 308). The extension is called.
3. To call the next extension that left a Message Waiting indication, dial  again.
<SLT on Dial Plan 1>
1. Lift handset. (Hear Message Waiting dial tone).
2. Dial 7, wait dial tone (See note 2).
3. Dial 
<SLT on Dial Plan 2>
1. Lift handset (Hear Message Waiting dial Tone).
2. Dial 